Specially designed for banding preglued PVC, polyester, melamine and veneer tapes. Possibility to band and trim tapes up to 3mm thick. Belt feeder for automatic workpiece feeding.

Top and bottom trimming by two independant motorized trimming units, equipped with TCT bits; possibility to trim with radius or straight edges. Scrapper unit and automatic tape feeding system. Front and rear flush cutting of the tape (for tapes up to 2 mm thick). Minimum heat up time. Electronic temperature control. Minimal, easy maintenance. Large surface table with special guides.

To ensure the tape is well banded, the EB35 incorporates two auxiliary rollers on the banding table and a special pressers set, allowing the optimum pressure of the panel on the banding unit. This ensures a correct banding, specially when using thick and rigide tapes. The EB35 is also equipped with a selection lever to regulate the correct workpiece position depending the tape thickness.

A heating unit Leister with electronic regulation, from 0° to 500°, is ensuring a correct banding temperature for any kind of tapes.

EB35 Details Input power 4,000w Min. panel thickness 13mm Max. panel thickness for 1mm 50mm Max. panel thickness for 2mm 35mm Max. panel thickness for 3mm 25mm Min. panel width 102mm Min. panel length 110m

EB35 Details Electronic temp control 0 - 500°C Working speed 4m/min Trimming unit no-load speed 10,000/min Voltage (Single Phase) 220-240v Weight 135Kg